repeat on horizontal pages crystal report

For the top border, insert a line in the page header and drag it down to the border. If you want to add horizontal lines, add a border to the bottom and two sides of the formula. Right click inside subreport / Page Setup / Increase 'Horizontal' Right click inside main report / Page Setup / Increase 'Horizontal' Change size of subreport object inside main report. Format the detail section to 'fit section'. If you only have some other numeric field, sort in ascending order and then note the value at the end of page 10 (where will equal 100, and then add that number into the selection formula. If you have a field in the second table that consists of consecutive numbers, use that in the selection formula, e.g., table.ID < 101. This could be a very large number, so you need to limit the records in the second table in the selection formula. This will cause the fields in the first table to repeat based on the number of records in the first table. Add a numeric field into the detail section and suppress. Add it to the report but DO NOT link the table to your first table.

Next find a table that has at least 100 records. Stretch the field vertically until you see a count of 10 on the first page. To start viewing messages, select the forum that you want to visit from the selection below. You may have to register or Login before you can post: click the register link above to proceed. Place this in the detail section (suppress the group header and footer sections and the report header). Crystal Report Header Repeat on every page If this is your first visit, be sure to check out the FAQ by clicking the link above.

Also place it in the detail section and suppress it. Insert a group on zip code and place the zip code in the page header.

Repeat on horizontal pages crystal report